Locate the section labeled "Unsaved Workflow" at the top of your dashboard.
This workflow allows you to use the new Wan 2.2 Model, here's a few things to know :
Wan 2.2 Uses two FP16 model so it load two model each generation, generation seems to be about 10 minutes. each model uses a different KSampler with total steps halved between them.
FP8 Clip seems to be enough, although i've included fp16 if you want to try it.
I2V 14B needs the wan 2.1 WAN_VAE, not the new 2.2 vae.
2.1 Loras don't seem to work well, those who do needs to be set at higher weight like around 3. Either try 2.1 Loras or wait for 2.2 Loras.
Those model are supposed to work with both 480p and 720 dimensions. Optimal length is still 5 sec, or 81 frames.
FPS is still at 16fps for 14B, this workflow interpolates to 32fps.
Basic instruction :
Load image, write your prompt, choose your length and dimensions and run.
You can change shift, scheduler and sampler, steps, cfg, but I'd advise to use basic parameters.
if you change the number of step be sure that both sampler have the total number of steps halved between them (e.g. 30 total steps = 15 steps for each KSampler).